For best results, read through the instructions and watch the video before affixing your reflectors: ​

​

1. Thoroughly clean the t-bar with rubbing alcohol (preferred) or water - be sure to dry completely before assembling stickers

2. With the tip-up on a flat surface, rotate the t-bar so the cylinder-shaped side (vs. the cone-shaped side) is pointing up

3. Locate the WHITE sticker’s backing tab, then peel the backing from the sticker - halfway at most (avoid touching the sticky side)

4. Carefully align the sticker so it is vertically centered within the t-bar cylinder (no overhang) - and horizontally centered nearest the base of the flag

   • Note - there is an intentional gap so the tape can adhere directly to the metal, improving the seal - when affixed correctly, the gap will be downward facing when the tip-up is in use

5. Roll the exposed side of the sticker around the bar, maintaining alignment

6. Remove the backing and roll the rest of the sticker around the bar, maintaining alignment 

7. Rotate the t-bar so the cone-shaped side is pointing up

8. Attach the RED sticker in the same manner as described above - be sure to hold the sticker in a smile position (vs. frown) for proper fit

9. After attaching stickers, use a hair dryer to heat and flatten each of the stickers to enhance memory and adhesion 

​

After use, inspect the edge of the sticker tape to check the seal. Reheat and flatten as needed.

​

Disclaimer - A sticker is a sticker. It's possible for it to come undone even when carefully affixed, particularly given the tightly-curved surface in combination with exposure to extreme weather conditions. If you're concerned, don't buy them. All sales are final.